Description
When your combine header knife is wearing down at the end sections, you know it’s time for a replacement before harvest season gets into full swing. These end sections take the most beating since they’re cutting through the toughest stalks and dealing with uneven ground conditions. A dull or damaged end section can cause the whole knife bar to bind up, costing you time and fuel when you should be cutting grain.
What You’re Getting
- Fine tooth design with 14 teeth per inch for clean, precise cuts through all types of grain
- Austempered heat treatment makes these sections incredibly tough and keeps the edge sharp longer
- Extra heavy thickness construction stands up to rocks, fence posts, and other field hazards
- Top serrated profile grabs and holds stalks for efficient cutting action
- Plated finish resists corrosion and helps sections slide through heavy crop conditions
Built for Real Farm Work
These end sections are designed for the workhorses of the grain harvest—John Deere 600, 700, and 900 series headers. Whether you’re running a 9600 through soybeans or pulling a 930 platform through wheat, these sections handle the job. The fine tooth pattern works especially well in small grains and soybeans where you need that clean cut to minimize shatter losses.
Made to Last
KONDEX builds these sections with austempered steel, which is heat-treated in a special process that makes the metal both hard and flexible. That means they’ll hold an edge but won’t snap when you hit something solid. The plated finish adds another layer of protection against rust and wear, important when you’re putting on those long harvest days.
Good to Know
These bolt right on with the standard M6 fasteners—no modifications needed. When you’re replacing sections, it’s a good time to check your knife head and guards for wear too. Keep a few spare sections on hand during harvest since end sections tend to wear faster than center sections.
Reviews
There are no reviews yet.