Description
When your hydraulic cylinder starts losing pressure or won’t hold steady under load, the problem might be hiding right at the head end. A worn or damaged cylinder head lets hydraulic fluid leak past where it should seal tight, leaving you with a cylinder that won’t do its job when you need it most. This replacement head gets your Cross cylinder back to full power.
What You’re Getting
- Precision-machined head designed specifically for 2-inch bore Cross cylinders
- Proper seal grooves and port threads that match your original equipment
- Heavy-duty construction that handles the pressure spikes common in farm hydraulics
- All the mounting points and connections you need for a direct swap
Built for Real Farm Work
This head works with Cross DB series cylinders like the 208DB, 210DB, and 224DB models found on everything from loader arms to three-point hitches. Whether you’re running a front-end loader, hay equipment, or tillage tools, these cylinders handle the heavy lifting that makes farm work possible.
Made to Last
This isn’t some lightweight replacement part—it’s built to the same standards as your original head. Cross manufactures these components to handle the constant stress of hydraulic systems, so you can count on it holding up through busy seasons and tough conditions.
Installation Notes
Before you start, make sure to drain the hydraulic fluid and relieve system pressure. Clean the cylinder barrel threads thoroughly and check for any damage that might prevent a good seal. When you install the new head, use proper torque specs and consider replacing the seals while you’ve got everything apart.
Reviews
There are no reviews yet.