Deep Groove Ball Bearing for Ford New Holland and Fiat Tractor Drivetrain Applications

Description

When you hear that subtle growling noise from your transmission or notice a bit more vibration than usual, there’s a good chance one of your drivetrain bearings is calling for attention. These systems work hard, with constant rotation at high speeds and varying loads that create heat and pressure that can destroy inferior seals. This precision ball bearing keeps your tractor’s rotating components running smoothly and quietly, whether you’re working the field or heading down the road.

What You’re Getting

• Double-sealed design (RS designation) that locks lubricant in and keeps dirt and moisture out
• Precision 35mm inner diameter and 62mm outer diameter for exact OEM fit
• 14mm width provides optimal load distribution and durability
• Quality steel construction built to handle the daily stresses of farm work
• Direct replacement that installs without modifications or special tools

Built for Real Farm Work

This bearing fits a wide range of Ford New Holland tractors from the compact 30 Series utility models up through the heavy-duty TS and TM series row-crop machines, plus various Fiat and Steyr models. Whether you’re running a smaller tractor for chores and light fieldwork or operating a larger machine for serious cultivation and harvest operations, this bearing supports critical rotating shafts in transmission, PTO, and drivetrain applications.

Made to Last

The sealed design is what makes this bearing tough enough for agricultural use. Proper sealing also keeps contamination out of your PTO system, protecting expensive gears and bearings from the dirt and moisture that cause premature wear and failure. The double rubber seals maintain their integrity even in dusty conditions and temperature swings, while the precision manufacturing ensures smooth operation under the varying loads that farm equipment faces.

Installation Notes

This is a press-fit bearing, so you’ll need a bearing puller for removal and a press or installer for proper installation. When replacing spigot bearings, it’s smart to check the shaft condition and replace any worn seals at the same time. Clean the bearing bore thoroughly before installation and make sure the new bearing seats fully and squarely in its housing.