Description

Nothing’ll shut down your day faster than fuel problems, and if your filter housing is cracked, leaking, or the threads are stripped, you’re looking at air in the system and all the headaches that come with it. This housing secures your fuel filter and keeps that critical seal between your lift pump and injection system, so fuel flows clean and air stays out where it belongs.

What You’re Getting

Precise fit that matches your tractor’s fuel system routing and eliminates guesswork
Quality construction that handles the vibration and temperature swings of field work
Quality fittings that seal properly without over-tightening, preventing damage to expensive pump components
Direct replacement design – no modifications or adapters needed to get back to work

Built for Real Farm Work

This filter housing fits your John Deere 6M series and 6R series tractors, the workhorses that handle everything from loader work around the farmyard to precision field operations during planting and harvest. Whether you’re running GPS-guided equipment that demands consistent power or pulling heavy implements through tough conditions, reliable fuel delivery keeps you productive when time matters most.

Made to Last

Modern diesel fuels and biodiesel blends are tough on fuel system components, but this housing is specifically designed to handle current fuel formulations without degrading. It’s built to withstand the constant pressure changes and temperature cycles that come with daily farm use.

Installation Notes

Have plenty of rags ready – fuel will drain when you disconnect lines, and clean all connection points thoroughly before installation since any dirt here goes straight to your injection pump. After installation, prime the system and check for leaks before starting, then run the engine and recheck since some leaks only show under pressure.