Description

When you’re dealing with a wobbly auger, noisy conveyor, or equipment that’s vibrating more than it should, chances are you’ve got a worn bearing that needs replacing. This 1-inch pillow block bearing gets your machinery running smooth again, whether it’s on a grain handling system, tillage equipment, or any other farm implement that uses a 1-inch shaft.

Key Features

Cast iron housing built tough enough to handle the dirt, moisture, and constant vibration of farm work
Greasable design with fittings that let you pump in fresh grease to extend bearing life
Set screw shaft lock holds tight on smooth shafts without needing keyways or special machining
Wide inner race design accommodates slight shaft misalignment that’s common on field equipment
Self-aligning insert bearing adjusts to shaft movement and reduces wear

Built for Real Farm Work

This bearing fits on any 1-inch diameter shaft where you need solid support and smooth rotation. You’ll find these on grain augers, conveyor systems, tillage equipment drive systems, and countless other applications around the farm. The 2-hole mounting pattern makes it easy to bolt down to angle iron, channel, or custom brackets.

Made to Last

The cast iron housing won’t crack like cheaper plastic units, and it dissipates heat better than steel housings. The bearing itself uses quality steel races and ball bearings that handle both radial and thrust loads. The rubber seals keep contaminants out while holding grease in, even in dusty harvest conditions.

Installation Notes

Mount the housing first, then slide your shaft through and tighten the set screws. Make sure the shaft is clean and free of burrs where the set screws contact it. Pump grease into the fitting until you see fresh grease at the seals, then back off slightly. A little grease showing at the seals is normal and actually helps keep dirt out.