Description

When you’re fluffing up windrows to get your hay drying just right, the last thing you want is worn-out tedder tines that won’t pick up properly or keep breaking on you. These replacement teeth for your Kuhn KT-3 tedder are built to handle the daily grind of moving hay around, turning those tight windrows into fluffy, fast-drying swaths that’ll cure evenly before you bale.

What You’re Getting

Heavy-duty .375 inch wire construction that flexes without breaking when you hit rocks or stumps
Bright yellow coating makes it easy to spot missing or damaged tines during your morning walk-around
12-1/2 inch length from the coil gives you the right reach for thorough hay pickup
Rear offset design works perfectly with your KT-3’s rotor spacing and rotation
Comes packed 20 per carton so you can replace a whole section at once

Built for Real Farm Work

This tine is specifically made for Kuhn KT-3 series tedders – those reliable workhorses that keep your hay operation running smooth. Whether you’re tedding first-cut alfalfa or getting that second cutting of grass hay ready for the baler, these tines will grab and toss the hay just like they should.

Made to Last

Farm equipment takes a beating, especially hay tools that spend their time bouncing across stubble fields. The .375 inch wire diameter gives you the strength to handle heavy windrows without bending, while the spring steel construction flexes when you hit the inevitable rock or root that jumps out at you.

Good to Know

These mount right onto your existing tine arms with the same hardware you’ve got now. A quick tip from the field – when you’re replacing tines, check the arm bolts and nuts too since they tend to work loose over time. It’s a lot easier to tighten them up while you’ve got the old tines off than to crawl under there later.