Description

When your hydraulic system’s getting sluggish or you’re starting to see contamination in your hydraulic fluid, a good filter head is what stands between clean operation and expensive repairs. This F1 hydraulic filter head gives you the solid foundation you need to keep spin-on filters doing their job—protecting your pumps, valves, and cylinders from the dirt and debris that can turn them into costly paperweights.

What You’re Getting

Sturdy filter head designed for F1 series spin-on hydraulic filters
3/4 inch NPT ports that fit standard hydraulic line connections
15 PSI bypass valve protects your system when the filter gets restricted
Heavy-duty construction that handles the pressure and vibration of farm work
Direct replacement design that bolts right in where your old head was

Built for Real Farm Work

This filter head works with tractors and hydraulic equipment that use F1 series filters. It’s rated for 200 PSI pressure and operates in temperatures from -65 to +300 degrees F, so whether you’re working in the heat of summer harvest or cold winter feeding, it’ll keep doing its job. The 3/4 inch ports make it compatible with most standard hydraulic setups.

Made to Last

Farm hydraulic systems take a beating, and this filter head is built to handle it. The machined housing resists corrosion and maintains proper seal integrity even when your tractor’s bouncing across rough ground. The 15 PSI internal bypass keeps hydraulic fluid flowing even if the filter gets clogged, preventing system damage while reminding you it’s time for a filter change.

Installation Notes

Make sure to drain your hydraulic system before removing the old head, and have a new filter ready to install. Apply a thin coat of hydraulic fluid to the filter gasket before threading it on—hand tight plus 3/4 turn is usually enough. Prime the system slowly after installation to avoid air locks.